Printed Circuit Boards (PCBs) are known as the "mother of the electronics industry." Their manufacturing process heavily relies on chemical processing, essentially a precise "carving" and "bridging" process on a copper foil substrate.
Based on the production process, PCB chemicals can be broadly categorized into four main types:
1. Imaging & Etching Chemicals
This stage defines the circuit pattern. Photoresist is used to protect the desired traces, while unwanted copper is etched away.
Developer: Typically uses sodium carbonate (Na₂CO₃) to wash away the photoresist that hasn't been exposed to light, revealing the circuit pattern.
Etchants: This is the main component of the "carving" process. It commonly uses acidic copper chloride (CuCl₂) or alkaline ammonia systems to dissolve the exposed copper foil.
Stripper: Typically uses sodium hydroxide (NaOH) to peel off any remaining photoresist film protecting the traces after etching.
2. Hole Wall Conductivity and Electroplating Chemicals (PTH & Electroplating)
This is to enable conductivity between the front and back sides of the circuit board or between multiple layers.
Black Hole/PTH Solution: To make the non-conductive hole walls (resin material) conductive, palladium catalyst or carbon black is used, followed by electroless copper deposition.
Electroless Copper Plating Solution: Primarily copper sulfate, sulfuric acid, and various additives (such as gloss agents and leveling agents), this solution thickens the copper layer between the traces and holes, ensuring conductivity.
Micro-etchant: Such as sodium persulfate or ammonium persulfate, used to roughen the copper surface, increasing the adhesion between layers.
3. Solder Mask & Surface Finish Chemicals
This is to protect the circuitry and ensure components can be successfully soldered onto the board.
Solder resist (green paint/ink): Typically made of epoxy resin, it protects the circuitry from oxidation and prevents bridging short circuits during soldering.
Surface treatment solutions: To prevent oxidation of exposed copper pads, various methods are used:
OSP (Optical Sterile Plating): An organic solder resist film.
ENIG (Enhanced Nickel Injection Gold): Contains electroless nickel and immersion gold plating, providing a smooth and wear-resistant solder surface.
Flux: Aids in solder paste adhesion.
4. Process Maintenance & Treatment
Soldering Solution: If tin-lead acts as a protective layer during the process, it must be removed using an acidic solution.
Defoamers and wetting agents: Ensure uniform distribution of various solutions in narrow apertures and fine lines.
Wastewater treatment agents: PCB wastewater contains high concentrations of heavy metals (copper, nickel), requiring specialized chelating agents and flocculants for precipitation and recovery, in compliance with environmental regulations.
